Product 2/9
Flash Tune Version Update - Focus ST

Flash Tune Version Update - Focus ST

Starting at: $50.00USD

Previous Flash Tune Order #:

For E30 tunes ONLY (Includes Datalog Refinement)

High Torque E30 (+15-20 ft/lb)

Further tuning using data collected from your car:

*** Datalog Refinements will adjust your tune for your
specific car. This means the tune may be changed for safety
and/or power based on the data collected in the logs.
Datalogging instructions will be sent via e-mail. ***

Import calibration changes from PREVIOUS Datalog Refinement:

Previous Datalog Refinement Order #:

Please update your Accessport firmware BEFORE selecting

Item is in stock

Description

The Details

To use a version update, you will need to be on a V9.00 or newer tune. Older tunes than this will NEED to go through a Modification Update as we need to rebuild the tune from scratch.

This update WILL NOT add or change any settings, features, fuel types, or account for any new modifications installed on the car. It is STRICTLY for tunes that only need their versions updated to the latest spec. All of the features and options for the tune you are updating will be present in the new version.

  • If you want to get your tune updated to the latest spec and add/change any settings, features, fuel types, or account for any new modifications click here.
  • If you want to keep your current version but want to add/change tune settings or features click here.

 

Update History

Our current Flash Tune version (as of Jan 25, 2023) is 10.30.

Version 10.20 to 10.30:

- Improved take-off in 1st gear
- Reduced rev hang when shifting

- Improved engine braking

Version 10.10 to 10.20:

           - Fueling delivery improvements

Version 10.00 to 10.10:

           - Smoother throttle tip-in

Version 9.00 to 10.00:

- More safe power and torque based on thousands of tunes and datalogs analyzed
- More adaptable wastegate strategy for modified cars

- Smoother tip-in and gear change strategies
- The reduced likelihood of torque limit and fuel pressure too high codes

Version 8.10 to 9.00:

- Faster adapting, more responsive ignition timing, and knock management
- Idle dip improvement as the car comes to a stop
- Fuel system improvement to increase combustion efficiency
- Air fuel ratio targets optimized for pump gas and ethanol tunes
- Improved STuned traction control for less momentum loss during cornering. If you don't have this option, you can add it here via a tune adjustment.
- Added high torque (HT) E30 option (+15-20ft/lb from 2500-5000 RPM over regular E30)
- Replaced Medium crackles with Progressive Crackles. If you want progressive crackles, you will need to add them here via a tune adjustment.

Version 8.00 to 8.10:

- Added support for adjustable Launch Control, Flat Foot Shifting, and Driving Rev Limit

Version 7.10 to 8.00:

- Broadened torque curve at peak turbo efficiency
- Refined knock control response and adaptation
- Adjusted fueling response to lessen HPFP strain at peak torque
- Improved Rev Limiter response at redline to reduce engine strain if the rev limiter is hit
- Improved throttle response during takeoff
- Added throttle mapping options: linear, aggressive
- Added WMI support

Version 7.00 to 7.10:

- Better boost holding and higher sustained torque post spool.
- More consistent wide open throttle air-fuel ratios.
- Reduced cruise and idle AFR oscillation on vehicles with aftermarket downpipes.
- V2 "crackles and pops" for exhaust sound. Louder, crisper crackling that stops 1-3 seconds after the lift. More audible with all exhaust setups. Less fuel is used during over-run with this iteration. See the video below.

Version 6.10 to 7.00:

- Crisper, more direct shifting and take-off
- Faster fuel enrichment response and high-pressure fuel pump pressure improvement
- Added further protection from high RPM overboost conditions due to wastegate failure
- Option to add "crackles and pops" to exhaust sound

Version 6.00 to 6.10:

- Throttle response improved to smoothen take-off and clutch engagement in 1st gear
- Tighter load and fuel controls to prevent fuel pressure drops, especially in very cold climates
- Timing compensation changes to reduce acceleration tip-in knock

Version 5.10 to 6.00:

- Higher torque/power and faster boost response in the 3500-4500RPM range for pump and E85 fuel tunes
- Finer adjustments based on the modifications installed on the vehicle (such as exhausts, intakes, and intercoolers)
- Improvements to ignition timing controls
- Charge Air Temperature sensor reading fix for MY2015 Focus ST. 

Version 5.00 to 5.10:

- Improved FFS and high RPM throttle response post shift

Version 4.10 to 5.00:

- Maps rebuilt to match the latest COBB FW released June 24, 2015.
- Further improvements to stabilize cold starting idle
- Further improved shifting and reduced rev hang
- Improved LC and FFS for easier activation
- Soft rev limiter implemented before fuel cut limiter

Version 4.00 to 4.10:

- Maps rebuilt to match the latest COBB FW released on April 8, 2015

Version 3.00 to 4.00:

- Smoother cold start and less idle hunting when the engine is still cold

Version 2.00 to 3.00:

- Much smoother shifting
- Performance optimizations in both low and top end through VCT adjustments
- Changes made to throttle mapping to improve smoothness and response

Version 1.00 to 2.00:

- Allows option for rolling map switching
- Enables both the fuel cut and throttle cut launch control limiters
- Changes made to throttle mapping to improve smoothness at low throttle inputs
- Increased torque output for all modification levels
- Increased response and quicker turbo spool for all modification levels
- Increased top-end power for all modification levels

 
 

The Options

 

Datalog Refinement: 

Purpose:

  1. Enhance the performance of your Flash Tune IF AND ONLY IF there is leeway or headroom, OR make adjustments based on datalogs to ensure your car operates safely with your local fuel and particular environment using a SINGLE tune iteration.
  2. To report if there are any issues and make suggestions on how to correct them (swapping parts, repairing leaks, changing fuel)
  3. If your car is running optimally on your local fuel or a particular environment, you will receive a full report on its performance.

** DISCLAIMER **: ALL CHANGES WILL BE BASED ON THE DATALOGS RECEIVED AND OUR EXTENSIVE EXPERIENCE AND EXPERTISE (THIS MEANS THAT WE WILL EITHER INCREASE PERFORMANCE OR MAKE ADJUSTMENTS FOR ENGINE SAFETY). AS SUCH, WE CANNOT AND WILL NOT GUARANTEE THAT PERFORMANCE WILL ALWAYS BE ADDED.

For more information click here

 

Datalog Refinement Update: 

This allows us to import any changes based on a previous Datalog Refinement to your new updated tune. Please ensure to enter the correct order number associated with the Datalog Refinement that you want your updated tune to be based on.

 

 

 

 

 

Features

  • Model: Mk3_FoST_FT_Ver_Update
  • 318 Units in Stock
  • Manufactured by: Stratified Automotive Controls

Reviews

Be the first to write review.